Ladder Type Joint Reinforcement or Corner Wire: Which Masonry Detail Fits?

Where each option fits

The masonry joint reinforcement ladder type wire mesh comes in continuous lengths for embedding in horizontal mortar joints. Standard sizes cover 4-inch through 16-inch walls, with other widths available on special request. It suits a straight wall run where the reinforcement width must match the wall section.

The masonry joint reinforcement Corner wire is made for masonry corners and is available in 8-inch and 12-inch sizes. It suits an inside or outside turn where a straight length changes direction and a corner detail is required.

Specification comparison

The shared tensile strength, minimum yield point, coating amounts, and cross-rod spacing make these values straightforward to place on one purchasing checklist. The configuration and size range determine which option fits the wall layout.

Match the product to the wall layout

For a straight masonry wall, select ladder type joint reinforcement by wall width and wire option. Picture the mesh embedded in each planned horizontal mortar joint, then match its width to the wall section. View the ladder type joint reinforcement product page for the available configuration from SHIJIAZHUANG TANGCHAO METAL PRODUCTS CO.,LTD.

At an inside or outside 90-degree turn, use the corner wire detail and choose between the 8-inch and 12-inch sizes. Mark every turn on the wall layout and separate straight-run quantities from corner quantities before requesting a quote. Send the wall thicknesses, corner count, required finish, and estimated linear footage to the supplier.